ELTAKO TLZ12-8E-230V UC PDF

Manufacturer name, Eltako. Manufacturer number, TLZEV+UC. GTIN, Country of origin, Germany. Customs tariff number, gThe Standardg TLZ12 8E 23 V UC replaces the TLZ12N0 V and TLZ12 8E V+V uC. gThe Allrounderg TLZ12D 23 V UC replaces the TLZ12M V+V uC. g The Simpleg . Also visit TLZ12D V +UC. Eltako Staircase time switch TLZplus 1; 2; 3; 4 Matching products. Eltako Staircase time switchTLZ Manufacturer, Eltako. Manufacturer.

Author: Jurn Brataxe
Country: Czech Republic
Language: English (Spanish)
Genre: Photos
Published (Last): 20 August 2018
Pages: 261
PDF File Size: 20.94 Mb
ePub File Size: 7.92 Mb
ISBN: 269-5-19859-235-9
Downloads: 22747
Price: Free* [*Free Regsitration Required]
Uploader: Meztigar

With the bottom rotary switch the required dim function can tlz12-8d-230v set. If the switch is opened briefly after closing, the light is dimmed until the next time it is opened again briefly.

The set release delay RV delay time starts when the control contact opens; the fan stops on time-out.

This results in an standby consumption of only 0. For this reason, direct sales to end-users, e. R loads ohmic loads, e.

In the meantime central commands are not executed. In these settings the special switching operation for childrens rooms is not possible and no wound inductive transformer must be dimmed.

The top rotary switch tl1z2-8e-230v the off-delay time from 1 to 12 minutes. However, after an interruption the elapsed time is stored. They save the consumption figures in non-volatile memories that are viewable at any time.

Soluções Eléctricas –

If N is connected, the zero passage switching is active. Used to compensate for inductive interference voltages on control leads.

Control voltage V. Same terminal connection as the electromechanical impulse switch S V. After that is switched off.

Eltako Tlz61np230v UC Timer per Luce

Very low switching noise. Control voltage, supply voltage and switching voltage V. Fluorescent lamps with conventional ballast units parallel compensated VA.

  IMUNOLOGIA ROITT PDF

Not suitable to feed back the switching voltage signal of a dimmer switch. Same terminal connection as the electromechanical impulse switch S V.

Contact position indication with two LEDs. Similarily, provision made for local control through A3 and A4 are not shown. With three switch positions: In addition electrically isolated universal etako voltage from 8 to V UC. If applicable the dimmer will be switched on at the stored brightness level after the supply voltage is recovered. In this case, it is only for DOWN that the direction is reversed tlz12-8f-230v time-out of the time lag selected by means of the top rotary switch, e.

As long as no major load is turned on, one pole of the monitored circuit remains isolated from the mains. The accrued switch-on time is continuously displayed.

Staircase lighting timer, TLZ12-8E-230V+UC

When set to the function ER this device is suitable to feed back the switching voltage signal of a dimmer switch. Universal control voltage from 8 to V UC. With control inputs for push-button light switches and light switches.

By this the switching capacity for one lamp will be increased according to the table depending on ventilation conditions up toor W or alternatively for additional lamps up to W per each capacity enhancer. With double connections for push-button and lamp in order to cu either above or below or only below. SS Technical data page J7.

The multiplier xA will be set with the middle rotary switch xA and offers values between 1and With 2 sealing caps PK36Protection degree lP50 for mounting in distribution cabines with protection class IP51Maximum conductor cross section 6 mm2 N and L terminals 16 mm2, S0 terminals 6 mm2Compliance with: The year after the year of assessment of conformity is important for the follow-up calibration.

  DIRTY SNOW SIMENON PDF

Any return is excluded. Control voltage and supply voltage V. Accurate timing is self-evident for this electronic device as well as noiseless operation.

With manual control and switch position indicator. They offer a highly reduced switching noise and further attractive advantages, such as multifunction, central control, zero passage switching for AC voltage, minimized control power demand and universal control voltage.

Holding down the push-button during the dimming down process dims up and stops the snooze function. With special switching tlz12-8e-203v for children’s rooms: With double connections for push-button and lamp in order to connect either above or below or only below. We use cookies to save your settings and to immediately show you the right price information next time you visit our site. Therefore, the blue momentary-contact switches are marked and.

Marking tl1z2-8e-230v both the devices and the flz12-8e-230v material. The settings ESL consider the special conditions regarding dimmable energy saving lamps: In addition, the lighting is immediately switched on again after a power failure if the set time has not yet elapsed, to increase security. The setting ER selects the function in brackets.

The off-delay timers with universal voltage offer additional applications as here even different potentials for switch and fan can be applied. At first an inrush current of 30mA is specified.

Contact position display with two LEDs.